Table of Contents
Advertisement
Gas equipment system
this consists of a control knob (11) with built-in safety pilot, a burner with igniter plug and
a piezo-gas igniter.
the control knob has 3 positions:
MAX : high cooling capacity,
MIN: low cooling capacity,
*Press: off-position = gas supply to burner is shut off.
if, for any reason the gas flame extinguishes, the ignition control is working automatically
and shuts off gas supply.
Igniting the gas burner
Open the gas valve of the gas cylinder, press the gas valve knob (11) in the panel, wait
approx. 15 seconds, turn the pressed knob to the left, a click of the igniter can be heard and
the gas flame is ignited.
Hold the knob (11) pressed in this position so that the flame remains burning. it might be
possible that this operation has to be repeated a couple of times, especially if the appliance
has not been used for a long time or if the gas cylinder has been changed. there can be
air in the system, which has to be forced out. It is necessary to check that the pilot is lit by
looking through the hole at the back near the burner (15). if the flame fails to light, wait
at least a minute before trying again. Please check the gas gauge (9) at the top of the unit:
when the white line is in the green field, the gas pressure is OK.
leave the knob for some time in MAX position; after a sufficiently long cool down period, a
lower position can be selected, till MiN position.
Once sufficient refrigeration has been obtained in the cooling tank at the MAX position, the
control knob should be turned to the MiN position by low outside temperatures or when
the refrigerator is only lightly loaded respectively the ambient temperature is below +18°c,
in order to avoid overfreezing the contents.
Shutting down gas operation
•
close gas cylinder or pressure regulating valve.
•
turn knob (11) clockwise to the *Press position.
FOOD AND DRINk STORAGE
•
foodstuffs and drinks should always be sealed when stored in the cooling unit.
Thus, changes in taste and smell are avoided.
•
food and drink should be so placed in the cooler so as to allow air to circulate
freely.
•
Do not place hot food or drinks in the cooler!
•
Under no circumstances should inflammable liquids and/or gases be stored in the
cooler. explosion hazard!
ICE CUBE TRAY
the provided ice cube tray can be filled with water and put on top of the inside cooling
element to make ice cubes.
*Press position.
position.
- GB-8 -
Advertisement
Table of Contents
