Table of Contents
Advertisement
Connecting the cooling unit to the gas cylinder
CAUTION: always stay clear of any source ignition during this operation. Do not smoke.
Connect the cooler in the following order:
Gas cylinder > pressure regulator > appliance
Be sure that the connections are tightened very well, check this regularly, manually is not
good enough. When you change the gas bottle it is possible that the connection is not tight
enough.
the gas connection tube at the rear of the appliance is designed for a standard Nf XPD 36
110 butane / propane flexible hose. it is essential to follow the assembly and connection
instructions for the appliance to be connected. excessive twisting and bending are to be
avoided. Bends in the gas hose must have a radius of more than 40 mm. The length of the
hose must not exceed 1.50 m.
if you wish to check for leaks, please use soapy water, do not use a flame.
It is prohibited to check for leaks with a flame.
Do not smoke: danger of explosion and burns.
When changing the gas cylinder and/or disconnecting the hose, it is mandatory to close the
valve of the gas cylinder.
Replace the hose if it is damaged or if it becomes porous and in any case before the expiry
date printed on the side.
- GB-7 -
Advertisement
Table of Contents
