Table of Contents
Advertisement
Quick Links
SAFETY INFORMATION AND OPERATIONS MANUAL
Read these instructions completely before beginning installation.
Failure to follow them could cause a heater malfunction resulting in
serious injury and/or property damage.
WARNING: All electric heaters have hot and arcing or sparking parts
inside. Do not use it in areas where gasoline, paint or fl ammable
liquids are or are stored.
This fi replace meets the construction and safety standards of H.U.D.
for application in manufactured homes when installed according to
these instructions.
INSTALLER: Leave this manual with the appliance
CONSUMER: Retain this manual for future reference
EWH38
EWH58
EWH95
Advertisement
Table of Contents
Summary of Contents for HomComfort EWH38
- Page 1 EWH38 EWH58 EWH95 SAFETY INFORMATION AND OPERATIONS MANUAL Read these instructions completely before beginning installation. Failure to follow them could cause a heater malfunction resulting in serious injury and/or property damage. WARNING: All electric heaters have hot and arcing or sparking parts inside.
-
Page 2: Table Of Contents
Table of Contents Safety ..........2 Locating Fireplace ......6 Listing ..........3 Installation ........6 Product Dimensions ....... 4 Operation ........8 Box Contents ........5 Frequently Asked Questions... 9 Unpacking and testing ....5 Troubleshooting ......10 Safety WARNING: Improper installation, Do not install fi... -
Page 3: Listing
Listing Approvals This heater has been tested in accordance with and conforms to UL 2021 for Fixed and Location Dedicated Electric Room Heaters and is certifi ed CSA 22.2 No.46. EWH95 EWH58 EWH38 Voltage AC 120V/60Hz AC 120V/60Hz AC 120V/60Hz Amperage 12.1 A... -
Page 4: Product Dimensions
Product Dimensions... -
Page 5: Box Contents
Box Contents (1) Mounting Bracket (2) For EWH95 (1) Remote (1) Fire Unit (1) Fastener Package (2) for EWH95 (1) Glass Face Unpacking and Testing Carefully remove unit from box. Prior to permanently installing unit, test to make sure unit operates properly. To do this, plug unit’s power supply cord WARNING: Do not operate the into a conveniently located 120-volt... -
Page 6: Locating Fireplace
Locating Fireplace CAUTION: Do not expose the heater to the elements (such as rain, etc.) CAUTION: Wear gloves and safety glasses for protection during installation and maintenance This electric fi replace can only be installed on a wall. Installation WARNING - RISK OF FIRE! WARNING: If the information in The power cord must not be these instructions is not followed... - Page 7 Wall-hung Installation: 1. Hang the mounting bracket with the washer head screws and wall anchors that are included. Wall anchors should be used at the highest outside corners. Be certain that at least two screws are driven in to solid backing. 2.
-
Page 8: Operation
Operation The main power switch is located on the right side of the unit. To turn on the fi replace, toggle the main power switch ON. There are also (4) buttons and (4) LED lights P r e s s t h e P O W E R b u t t o n t o t u r n t h e electric fireplace ON. -
Page 9: Frequently Asked Questions
Frequently Asked Questions Q. How do you program the remote control? A. The remote comes preprogrammed. No programming is necessary. Q. What distance can the remote be used from the fi replace? A. Maximum range for the remote control is within 25ft. Q. -
Page 10: Troubleshooting
Troubleshooting SYMPTOM PROBLEM TEST SOLUTION Appliance has Unplug the appliance, overheated and safety allow appliance to cool device has caused the for 15 minutes; plug The appliance turned thermal switch to open appliance back in off and will not turn ON ------------------------------ ------------------------------ Circuit breaker has... -
Page 11: Wiring Diagram
Wiring Diagram AC-IN AC-L AC-L2 AC-L1 750W 750W... - Page 12 FOR CUSTOMER SERVICE THIS MANUAL WILL HELP YOU OBTAIN EFFICIENT, DEPEND- ABLE SERVICE FROM YOUR NEW HEATER KEEP THIS MANUAL IN A SAFE PLACE FOR FUTURE REFER- ENCE. WHEN WRITING, ALWAYS GIVE THE FULL MODEL NUMBER AND SERIAL NUMBER WHICH IS ON THE NAMEPLATE AT- TACHED TO THE APPLIANCE.