Wide Mode - Sony TRINITRON KV-29FS150 Service Manual

Geometry Adjustment
Geometry adjustment must be done for both color systems PAL and
NTSC.
H-Trapezoid Adjustment
1. Receive cross hatch/dot signal.
2. Adjust RV 1800 on CV Board to make H-Trapezoid distortion best/to
obtain the center illustration shown in TABLE 1.
Category Function
GEOM 000 H Position
(HPOS)
GEOM 001 H Parallelogram
(HPAR)
GEOM 002 H Bow
(HBOW)
GEOM 003 Linearity
(VLIN)
GEOM 005 EW Width
(HSIZ)
GEOM 006 EW Parabola/Width
(EWPW)
GEOM 007 EW Upper Corner
(UCOP) Parabola
GEOM 008 EW Lower Corner
(LCOP) Parabola
GEOM 009 EW Trapezoid
(EWTZ)
GEOM 011 V-Amplitude
(VSIZ)
GEOM 012 S-Correction
(SCOR)
GEOM 013 V-Shift
(VPOS)
KV-29FS150
Illustration
Note: Adjust HSIZ
16.6 + -(SPCB) _ 50Hz
14.8 + -(PAL Monoscope) _ 50Hz
15.3 + -(NTSC Monoscope) _ 60Hz
Note: Adjust VSIZ
12.6 + -(SPCB) _ 50Hz
11.3 + -(PAL Monoscope) _ 50Hz
11.7 + -(NTSC Monoscope) _ 60Hz
TABLE 1
Normal Mode 50Hz/60Hz
1. Input PAL Special Color Bar (SPCB) or PAL Monoscope (OTHER
model) and Video mode or NTSC Monoscope (NTSC model) signal
using a pattern generator.
2. Set Wide Mode to "OFF".
3. Use TABLE 1 to complete the adjustments by acesssing service
mode and then selecting the category item that needs adjusting by
pressing 1 or 4 .
Press 3 to increase the data value, or 6 to decrease the data
4.
value.
Press MUTING then 0 to write into memory.
5.

Wide Mode

1. Input PAL Special Color Bar (SPCB) or PAL Monoscope (OTHER
model) and Video mode or NTSC Monoscope (NTSC model) signal
using a pattern generator.
2. Set Wide Mode to "ON".
3. Copy NORMAL MODE 50Hz/60Hz adjusted data for the following
items:
GEOM: 011 VSIZ, 010 VSLP, 012 SCOR, and 003 VLIN
Use TABLE 1 to adjust the data by pressing 3 to increase the data
4.
value, or 6 to decrease the data value until the screen displays the
center illustration for all items except the following:
GEOM: 003 VLIN, 010 VSLP, 011 VSIZ, and 012 SCOR
Press MUTING then 0 to write into memory.
5.
KV-29FS150
20