Advertisement
Quick Links
BP7253-2
4/28/06
11:58 AM
READ AND SAVE THESE INSTRUCTIONS
SW350, SR330 & SW375
Wall Control, Remote Control &
Receiver Owner's Manual
Up
Down
Lights
Fan
Sleep
Off
Model
SW350
Wall Control
NOTE: The SW350 and SR330 controls
must be used with a SW375 receiver.
For use only with Emerson Ceiling Fan Models: F2100 2, F2200 2, F2300 1,
CF1 1, CF2300 1, CF2400 1, CF2454 2, CF2500 1, CF2600 2, CF2650 0,
CF2675 1, CF3500 0, CF3900 1, CF4500 4, CF4600 0 and CF4800 3.
Part No. F40BP72530002
Page 1
Ceiling Fan/Light
On
Remote Control
Model
SW375
Receiver
Up Light
Fan High
Air
Air
Fan Low
UP
DN
Down Light
Lights
Fan
Model
SR330
Form No. BP7253-2
Advertisement
Related Manuals for Emerson SW350
Summary of Contents for Emerson SW350
- Page 1 NOTE: The SW350 and SR330 controls must be used with a SW375 receiver. For use only with Emerson Ceiling Fan Models: F2100 2, F2200 2, F2300 1, CF1 1, CF2300 1, CF2400 1, CF2454 2, CF2500 1, CF2600 2, CF2650 0, CF2675 1, CF3500 0, CF3900 1, CF4500 4, CF4600 0 and CF4800 3.
-
Page 2: Safety Instructions
BP7253-2 4/28/06 11:58 AM Page 2 WARNING Safety Instructions WARNING: To avoid fire, shock, and serious personal injury, follow all instructions carefully. 1. Read your Owner's Manual carefully before installing the Remote Control, Wall Control, or Receiver. Retain Owner's Manual for future reference. 2. - Page 3 Page 3 General NOTE 2: On Model CF1, CF2400, and CF2800 Series Ceiling Fans, the red Your Emerson Ceiling Fan/Light Control and brown wires from the motor are consists of either a hand-held transmitter connected to red and brown wires from with wall caddy and/or a wall control as the reversing switch.
- Page 4 9. Install the setscrew (supplied in loose SW375 RECEIVER parts bag supplied with ceiling fan) in the motor coupling and tighten using 120V SUPPLY the 5/32" setscrew wrench (supplied SW350 WALL CONTROL Down with ceiling fan) (Figure 6). A loose Lights Sleep...
- Page 5 BP7253-2 4/28/06 11:58 AM Page 5 wire connectors around the motor Pull the hanger ball up tight against coupling, then slide the motor cover the pin and securely tighten the over the hanger pipe and rotate the setscrew in the hanger ball. A loose motor cover until the threaded studs setscrew could create the fan to protrude.
- Page 6 NEUTRAL accordance with the instructions in WALL BOX the downlight kit Owner’s Manual. SW350 WALL CONTROL Figure 11 Installation of SW350 3-WAY INSTALLATION Wall Control (One fan controlled by two different SW350 wall controls) (See Figures 12 and 13.) BLACK...
- Page 7 LOAD TRAVELER WIRES in the wall box and secure with wire connector supplied. 3-WAY WIRING DIAGRAM: RETROFIT 3-WAY WIRlNG DIAGRAM: NEW CONSTRUCTION Down Down Lights Lights Down SW350 Lights Down Lights WALL Sleep Sleep CONTROL Sleep Sleep SW350 WALL CONTROL...
-
Page 8: Troubleshooting
ON/OFF switch on desire to have the pull chain(s) hang from the SW350 or turning OFF the wall your ceiling fan, proceed as follows. switch (if using a SR330 Remote Uncouple the chain extensions(s), if Control). - Page 9 Press the Up/Down arrow buttons to reach CODE LEARNING PROCEDURE the desired intensity, then release the Turn the power off at the SW350 wall button when satisfied. control. NOTE: Both uplight and downlight will After a few seconds, turn the power back return to their pre-set intensity levels on at the wall switch.
-
Page 10: Security Function
BP7253-2 4/28/06 11:58 AM Page 10 To cancel the Sleep function, press the Fan On/Off button to turn the fan off. UP/DOWNLIGHT INDICATOR D. SECURITY Function LIGHT ON/OFF BUTTON When the Security button is pressed the Down Lights lights will flash and then come to full brightness. -
Page 11: Winter Mode
Page 11 B. FAN ( ) Function To cancel the Sleep function, press the Your Emerson fan operates at six different Fan On/Off button to turn the fan off. fan speeds (from low to high). When the D. WINTER Mode... - Page 12 What Will Emerson Electric Co. Do To Correct Problems: Emerson will replace a defective Emerson Remote Control, Wall Control, or Receiver at no charge to you. We will ship the repaired product or replacement to you at no charge, but you are responsible for all costs or removal, reinstallation and shipping of the product to Emerson.
Need help?
Do you have a question about the SW350 and is the answer not in the manual?
Questions and answers