Page 2
DESCRIPTION english english Start/stop button Standard or optional Variable control EXTREME accessories POWER Suction hold with extra long Bag full indicator shaft and mechanical power Suction opening control* Dustbag compartment opening 2 extension tubes or 1 teles- Handle copic tube* Electrobrush connector* 2 position cleaning...
Always turn off and unplug your appliance before maintenance or cleaning. Never use the appliance without dustbag, filter and motor filter protection. Only use original Rowenta accessories, bag and filters. Only connect Rowenta electrobrush ZR 155 in the electrobrush connector.
Page 4
VACUUMING english 3 • turn on your appliance Caution ! Check that dustbag and filter are in place before each use. Never use the appliance without dustbag and filters. 4 • adjust the suction power With the mechanical power control With the electronic power control : Soft (or low) / High / smooth...
MAINTENANCE AND CLEANING english 7 • change the dustbag or empty the textile filter When the bag full indicator is red, the bag is full or blocked with dust particles. If the indicator remains red with the nozzle lifted off the ground, change the bag.
Page 6
english Important ! Every 12 months change the HEPA filter . It is advised that you note on the filter the date of first use. Every 6 dustbags changes, replace the antibacteria microactive filter and clean the antibacteria motor protection with soapy water, rinse and leave to dry thoroughly before putting back into place.
FOR YOUR SAFETY english Read the instructions for use carefully and keep them in a safe place. Your vacuum cleaner is an electrical appliance: it must only be used under normal operating conditions. The appliance should be used and stored out of the reach of children.
Page 8
Pull out the cord until completely extended and press on the cord rewind command (see § 5). If the problem persists, send the appliance to your nearest Rowenta Approved Service Centre HELPLINE: If you have any product problems or queries, please contact our...
Need help?
Do you have a question about the Artec 2 and is the answer not in the manual?
Questions and answers