MSI 915PM User Manual page 53

MS-7033 M-ATX Mainboard
IDE Primary Master/Slave Ultra DMA
Ultra DMA 33/66/100/133 implementation is possible only if your IDE hard drive
supports it and the operating environment includes a DMA driver (Windows ME,
XP or a third-party IDE bus master driver). If your hard drive and your system
software both support Ultra DMA/33, Ultra DMA/66, Ultra DMA/100 and Ultra
DMA/133, select [Auto] to enable BIOS support. Setting options: [Auto], [Disabled].
SATA Devices Configuration
Press <Enter> and the following sub-menu appears:
On-Chip Serial ATA
This setting is used to specify the SATA controller. The settings are:
[Disabled] Disable the SATA controller.
[Auto]
[Combined]
channel
[Enhanced]
[SATA only]
PATA IDE Mode
This item is available for you to select the parallel ATA channel. Setting options:
[Primary], [Secondary].
SATA Port
This allows you to set the boot sequence of serial ATA port.
3-18
PATA and SATA will be arranged by BIOS, and you will be
able to see the IDE Device status listed in Standard COMS
Features.
PATA and SATA will be combined. Max. of 2 IDE drives in each
are available.
PATA and SATA will both be enabled. Max. of 6 IDE drives are
supported.
Only SATA is operating in legacy mode.