Wired Wan Connection - D-Link DIR-632 Quick Installation Manual

DIR-632

Wired WAN Connection

1. Go to the Net / WAN page, select the WAN connection and click the
Delete button.
2. Click the Add button.
3. In the General settings section, leave the Manual value.
4. From the Connection Type drop-down list, select the needed value.
5. From the Port drop-down list, select the Internet value.
6. Specify a name for your connection (any name for easier identification) in
the Name field.
7. If your ISP uses MAC address binding, in the Ethernet section, in the
MAC field, enter the MAC address registered by your ISP upon
concluding the agreement. To set the MAC address of the network
interface card (of the computer that is being used to configure the router
at the moment) as the MAC address of the WAN interface, click the
Clone MAC button. To set the address of a device connected to the
router's LAN at the moment, select the relevant value from the drop-down
list located to the right of the field.
8. For connection of PPPoE type: in the PPP section, enter authorization
data provided by your ISP (the username (login) in the PPP Username
field and the password in the Password and Password confirmation
fields), or select the Without authorization checkbox if authorization
is not required.
9. For connection of Static IP type: in the IP section, fill in the IP
Address, Netmask, Gateway IP Address, and Primary DNS
server fields.
10. For connection of Dynamic IP type: if your ISP has provided the address
of the DNS server, in the IP section, deselect the Obtain DNS server
addresses automatically checkbox and fill in the Primary DNS
server field.
Quick Installation Guide
16