Sonetics APEX-Series User Manual

H E A D S E T F E A T U R E S
APEX Triton
Power/Volume Power/Volume
control control
Charging Port Charging Port
Mic Placement
Place mic no more than 1/8"
from lips. Placement of mic is
critical for proper operation.
Power/Volume
control
Charging Port
Headset Adjustments
Behind-the-Head Headset Over-the-Head Headsets
Adjustable
headstrap
Adjustable
headband
Power/Volume
control
Adjustable
Boom
Over-the-Head Mush Mouth Headsets
Adjustable
headband
Power/Volume
control
Adjustable
Strap
CHARGING & INSTALLATIONS
Wall Adapter Charging
Only charge the Headset using the supplied 12VDC regulated wall
adapter. Using unregulated wall adapters will damage the Headset
charging circuit and components and void the warranty.
RED to Battery+
BLACK to Chassis Ground
Vehicle Charging
Note: Make fuse no further than 18" from the battery.
Note: Only replace fuse with the same type, 1.5A AGU.
1. The unterminated end of the supplied charging cable assembly
and fuse assembly must be wired to the vehicle per the diagram
above.
Adjustable
Boom
2. Observe correct polarity when connecting the charger cable to
12V from the vehicle. Connect the RED wire to +12V and the
BLACK wire to battery chassis ground. This will result in a positive
center terminal of the charger jack as shown in the illustration.
BLACK
3. Charge Headset completely before use with vehicle power 12V
supply or supplied wall mount charger
4. For maximum battery shelf life, turn OFF the Headset.
BATTERY INDICATORS
LED Indicators: Charging Depleted Battery
20 Minutes
0%
No Light
(First 20 Minutes of Charging)
Battery Level Indicator
Number of RED and GREEN
Flashes at Turn ON
Low Battery (2 hour battery life)
Vehicle Battery
Red LED Flashing Slow
1.5A Fuse
Very Low Battery (15 Minutes battery life)
Red LED Flashing Fast
30
25
20
15
10
RED
5
.
0
Degrees
-40 -30
Centigrade
Degrees
-40 -22
Fahrenheit
Up=PTT On
C
2 Hours
100%
A
Flashing Red Steady Green
(While Charging) (Fully Charged)
>
75%
50-75%
25-50%
B
<
25%
3 Beeps Every 10 Minutes
Up=PTT On
C
6 Beeps Every Minute
Battery Life vs Temperature
C
-20 -10 0 10 20 . . . . . 60
-4 14 32 50 68 . . . . . 140
Up=PTT On
C
P A I R I N G
With power ON to Base Station, press the "Pair" button until
Yellow LINK(S) LED's flash.
LINKS
LINKS
1 2 3 4 5
1 2 3 4 5
WIRELESS BASE
POWER INTERCOM PAIR
To pair Headset to Base Station; hold toggle switch UP, then
turn power ON to Headset or hold PTT button down on the
dome or mush mouth while turning power ON to Headset.
When BOTH Red/Green Headset LED's are alternating, release
toggle switch or PTT button. Headset will connect to base in
30 seconds.
Headset with
Toggle Switch
Toggle Up Power On
Headset with
PTT Button
PTT Button Power On
Power On
Headset with
Mush Mouth
PTT Button
When the Headset Green LED remains steadily ON the
headset is successfully paired to the base. If the Headset
Green LED flashes rapidly then repeat the pairing procedure.
Paired Not Paired