Table of Contents
Advertisement
2-1-10. AD Adjustment of Component (15k) System
1) Set input to AV4 (or 5).
2) Input component PAL 50% window Signal 90IRE in AV4 (or 5).
3) Set picture quality mode to [PC/GAME].
Send "RGB Level" Command.
4) Adjust Y_OUT_LEVEL until the Green detection value is within a setting value.
Detection setting value: 197 ±3
5) Set Video Signal to component PAL 50% window 20IRE.
6) Adjust Cb_OFFSET2 until the detection value of Blue becomes same as that of Green.
7) Adjust Cr_OFFSET2 until the detection value of Red becomes same as that of Green.
8) Repeat step 6-7 until it is in a detection setting value of 8).
+2
Detection setting value: 44
–6
R,G,B detection value dispersion: ±1
9) Repeat step 2-7 until it is in the detection setting value of 4) and 8).
10) Input component PAL 75% Color Bar signal into "AV4 (or 5)".
11) Adjust C_OUT_LEVEL until the detection value of (A) becomes same as that of (D), as
shown in the figure 2.
75% Color Bar
(A)
(B)
(C)
(D)
x
x
x
x
Wh Ye Cy G Mg R Bl Bk
Cautions :
The position of (A) excepts between
for 1/16 from an edge.
figure (1)
(A)
(B)
(C)
(D)
figure (2)
ML board CN304 3 pin
Blue output
`Û N Ü â „ f Ù Y vÑ ç D eô ã ˜ v {ñ F V˛ ~ ∏bKQå N § m A QzŸ
( h t t p : / / s c h e m a t i c . 5 d 6 d . c o m )
KE-MR42/50M1(CH) 2-6
Advertisement
Table of Contents
