Out of Range
Each time a command is performed the Responder LE will expect a
command confirmation from the system. If a command confirmation
is not received the
plays as an alert.
No Remote Output
Occasionally when a command is performed the remote may not
generate a command confirmation output or Out of Range output.
This indicates that the system received the command but it was an
incomplete command (e.g. Aux button pressed too short to activate
the trunk release) or it was an illegal message (e.g. the command
was corrupted due to local RF interference). These are temporary nor-
mal functions of the system and remote, perform the command again
within 10 seconds to return to normal operation.
Feature not Available
The Feature Not Available output (
generic one which varies in cause and solution depending upon the
command used:
Command
Runtime Reset
Sensor Bypass
Defroster
36
and transmit LED's flash and a long fault tone
Cause
Remote Start is Off
System is not armed
Remote Start is Off.
Not configured for
this.
LED on and long fault tone) is a
Reason/Solution
Only available when Remote Start is On
Only available when system is armed
Only available when Remote Start is On.
Only available when configured for
Defroster control.
© 2011 Directed Electronics. All rights reserved.