Setting The Crossover High/Low Pass Filter-X'over Hpf/Lpf - JVC KD-A925BT Instructions Manual

Setting the crossover High/Low Pass Filter—X'over HPF/LPF
1
[Hold]
2
] <Audio> ] <X'over HPF/LPF>
X'over HPF/LPF
Easy
Pro
3
] Select the adjustment method
[ Easy/ Pro ].
4
If "Easy" is selected in step 3...
HPF/LPF
Front
Full
cm/inch
1 Press 4 / ¢
speaker [ Front/ Rear/ Subwoofer * ].
* Displayed only when <On> is selected for
<Subwoofer On/Off>. (page 32)
2 Turn the control dial to select the
speaker size.
Front/ Rear :
Full [ Initial ]/ 4" (10cm)/
5-1/4" (13cm)/ 6-1/2" (16cm)/
6-3/4" (17cm)/ 7" (18cm)/
4x6" (10x15cm)/ 5x7" (13x18cm)/
6x8" (15x20cm)/ 6x9" (15x23cm)/
7x10" (18x25cm)
Subwoofer :
Full / 6-1/2" (16cm)/ 8" (20cm)/
10" (25cm) [ Initial ]/ 12" (30cm)/
15" over (38cm over)
to select the
3 Press 5 / ∞ to select the
measurement unit [ cm/ inch ].
4 Press the control dial to confirm the
settings.
If "Pro" is selected in step 3...
HPF/LPF
Front
HPF Off
–18dB/Oct
1 Press 4 / ¢
speaker [ Front/ Rear/ Subwoofer * ].
*
Displayed only when <On> is selected for
<Subwoofer On/Off>. (page 32)
2 Turn the control dial to select the cut
off frequency.
Front/ Rear :
HPF 30Hz — HPF 200Hz : Activates
the High Pass Filter (HPF). Frequencies
lower than the selected frequency are
cut off from the front/rear speakers.
HPF Off [ Initial ] : Deactivates HPF
(all signals are sent to the front/rear
speakers).
Subwoofer :
LPF 30Hz — LPF 200Hz :
[ Initial: LPF 80Hz ] : Activates the Low
Pass Filter (LPF). Frequencies lower
than the selected frequency are sent
to the subwoofer.
LPF Off : Deactivates LPF (all signals
are sent to the front/rear speakers).
3 Press 5 / ∞ to select the quality of
HPF/LPF [ –12dB/oct/ –18dB/oct/
–24dB/oct ].
[ Initial:
Front/ Rear : –18dB/oct,
Subwoofer : –12dB/oct ]
4 Press the control dial to confirm the
settings.
to select the
ENGLISH 29