Bbsk Kit Instructions - COZY W255F Installation And Operating Instructions Manual

WARNING: If you do not follow these instructions exactly, a fire or explosion may result causing
A. This appliance has a pilot which must be lighted by
hand. When lighting the pilot, follow these instruc-
tions exactly.
B. BEFORE LIGHTING smell all around the
appliance area for gas. Be sure to smell next to the
floor because some gas is heavier than air and will
settle on the floor.
WHAT TO DO IF YOU SMELL GAS:
•
Do not try to light any appliance.
•
Do not touch any electric switch; do not use any phone
in your building.
•
Immediately call your gas supplier from a neighbor's
phone. Follow the gas supplier's instructions.
1. STOP! Read the information on the safety label.
2. Turn temperature control knob clockwise
"LO".
3. Open cabinet door.
4. Depress and turn gas control knob clockwise
to "OFF".
5. Wait five (5) minutes to clear out any gas. Then
smell for gas, including near the floor. If you smell
gas, STOP! Follow "B" in the information on the
safety label. If you don't smell gas, go to the next
step.
6. Locate the pilot. (Follow metal pilot tube from gas
control).
7. Turn gas control knob counterclockwise
"PILOT".
1. Turn temperature control knob clockwise
"LO".
2. Open cabinet door.
BBSK KIT LIGHTING INSTRUCTIONS
FOR YOUR SAFETY READ BEFORE LIGHTING
property damage, personal injury or loss of life.
LIGHTING INSTRUCTIONS
GAS CONTROL KNOB
NOTE: Knob cannot be
turned from "PILOT" to
"OFF" unless knob is
pushed in slightly. Do
not force.
TO TURN OFF GAS TO APPLIANCE
•
If you cannot reach your gas supplier, call the fire
department.
C. Use only your hand to push in or turn the gas control
knob. Never use tools. If the knob will not push in
or turn by hand, don't try to repair it, call a qualified
service technician. Force or attempted repair may
result in a fire or explosion.
D. Do not use this appliance if any part has been under
water. Immediately call a qualified service technician
to inspect the appliance and to replace any part of the
control system and any gas control which has been
under water.
to
8. Depress gas control knob and hold in. Immediately
light the pilot with a match. Continue to hold the gas
control knob in for about one (1) minute after the
pilot is lit. Release gas control knob and it will pop
back up. Pilot should remain lit. If pilot goes out,
repeat steps 4 through 8.
•
If knob does not pop up when released, STOP and
immediately call your service technician or gas supplier.
•
If the pilot will not stay lit after several tries, turn the gas
control knob to "OFF" and call your service technician
or gas supplier.
9. Turn gas control knob counterclockwise
"ON".
10. Close the cabinet door.
11. Turn temperature control knob to desired setting.
to
3. Push in gas control knob slightly and turn clockwise
to
to "OFF". Do not force.
4. Close cabinet door.
Page 15
Pilot is
located
on side
of burner
to
P/N 91288 09/05