Sound Management System - Kenwood KDC-PSW9531 Instruction Manual

DTA Front/DTA Rear
DTA Subwoofer
Position Setting
• When the "2ZONE" of <Audio Setup> (page 11) is
"ON", the following setups are ignored.
- "X'Over"
- "DTA"
- "POSI"
- "Preset"
6
Exit Sound Field Control mode
Turn the [VOL] knob to select "Return".
Press the [VOL] knob.

Sound Management system

1
Select the source to adjust
Press the [SRC] button.
2
Show the Multi-function display
Press the [NEXT] button repeatedly until
"S.M.S" appears.
Refer to <Notes on Multi-function System> (page
9).
3
Enter Sound Management mode
Turn the [VOL] knob to select "S.M.S".
Press the [VOL] knob.
• When "2ZONE" of <Audio Setup> (page 11) is ON, you
cannot select "S.M.S".
4
Select the Sound Management item to
adjust
Turn the [VOL] knob to select the item you
want to select.
Press the [VOL] knob.
Multi-function item Sound Management Item
"Cabin" Cabin Setting
"Front" Speaker Select Front
"Rear" Speaker Select Rear
"Sub-W" Speaker Select Subwoofer
"Preset" Preset value storage/recalling
0 — 610 (cm)
Front-Left/ Front-Right/
Front/ ALL
• "Preset": You can store an adjusted sound control
value by selecting "Memory". Refer to
<Memory mode> (page 16). Also, you
can recall it by selecting "Recall". Refer to
<Memory Recall mode> (page 16).
5
Adjust the Sound Management item
Push the Control knob towards [4] or
[¢].
Each time you push the knob, the setting
alternates between the settings shown in the
table below.
Sound Managemnt Item Range
Cabin Setting
Speaker Select Front
Speaker Select Rear
Speaker Select Subwoofer
6
Exit Sound Managemnt mode
Turn the [VOL] knob to select "Return".
Press the [VOL] knob.
OFF/ Compact/ Sedan/ Wagon1/
Wagon2/ Minivan1/ Minivan2/
SUV/ Passenger Van
16cm/ 17cm/ 18cm/ 4x6/ 5x7/ 6x8/
6x9/ 7x10/ O.E.M./ 10cm/ 13cm
16cm/ 17cm/ 18cm/ 4x6/ 5x7/ 6x8/
6x9/ 7x10/ None/ O.E.M./ 10cm/ 13cm
25cm/ 30cm/ 38cm over/ None/
16cm/ 20cm
13
|
English