Advertisement
KD-S735R
2.2 CD Mechanism Assembly
QQ
2.2.1 Removing the CD mechanism control board
3 7 63 1515 0
(See Fig.1 and 2)
(1) Unsolder the part a and b on the CD mechanism control
board.
(2) Remove the stator fixing the CD mechanism control board
and the damper bracket (To remove the stator smoothly,
pick up the center part).
(3) Remove the screw A attaching the CD mechanism control
board.
(4) Remove the CD mechanism control board in the direction
of the arrow while releasing it from the two damper bracket
slots d and the front bracket slot e.
(5) Disconnect the flexible wire from connector on the pickup
unit.
ATTENTION:
Turn the FD gear in the direction of the arrow to move the en-
tire pickup unit to the appropriate position where the flexible
wire of the CD mechanism unit can be disconnected easily.
(Refer to Fig.2)
CD mechanism assembly
D
h
TE
L 13942296513
Front bracket
Pickup unit
FD gear
www
1-8
http://www.xiaoyu163.com
Damper bracket
D
a
h
c
D
d
CD mechanism
e
A
control board
b
Fig.1
Flexible wire
Shift the lock
Fig.2
x
ao
y
.
i
http://www.xiaoyu163.com
2.2.2 Removing the loading motor
8
(See Fig.3 to 5)
• Prior to performing the following procedure, remove the CD
mechanism control board.
(1) Remove the two springs f attaching the CD mechanism
assembly and the front bracket.
(2) Remove the two screws B and the front bracket while
pulling the flame outward.
(3) Remove the belt and the screw C from the loading motor.
f
B
Loading motor
Pull outward
Q Q
3
6 7
1 3
Flame
Loading motor
u163
.
2 9
9 4
2 8
CD mechanism control board
f
B
Front bracket
Fig.3
Front bracket
1 5
0 5
8
2 9
9 4
Fig.4
C
Belt
Fig.5
m
co
9 9
Pull outward
2 8
9 9
Advertisement
