Table of Contents
Advertisement
100 Mbps Mode Nonresponsive
If the Ethernet adapter does not appear to operate in the 100 Mbps transmission
mode:
• Make sure the hub you are using supports 100 Mbps operation.
• Make sure that your RJ-45 cable meets the 100BASE-T requirements.
• Make sure the Ethernet cable is connected to the hub socket that supports
100BASE-T mode, not 10BASE-T. The hub may have both 10BASE-T and
100BASE-T sockets.
PC Card (PCMCIA) Problems
PC Cards do not Function
• Make sure you have properly installed the driver for the card.
• Make sure the card is properly seated.
• Consult the card's manual or contact the vendor for troubleshooting.
PC Card not Recognized
• Remove and insert the PC Card again.
• Make sure there is no IRQ (interrupt request) conflict with the card. See
Windows
on-line help for solving IRQ conflicts.
®
• Reboot the ViewPad 1000 to see if the problem persists.
• The card may be defective. Try the card on another system, if possible.
PC Card Removal Locks Up Windows
If the Windows Crashes or Freezes after removing the PC Card:
Make sure the PC Card is not in use before removing it. Click on the PC Card
icon at the lower right corner of the task tray, select the card you wish to stop,
then click OK. In a few seconds, Windows will prompt you to remove the card.
Performance Problems
Overheating
If the ViewPad 1000 becomes hot:
• In a high temperature operating environment, 95 degrees Fahrenheit (35
degrees Celsius) or more, the ViewPad 1000's case bottom can reach 120
degrees Fahrenheit (49 degrees Celsius).
• Make sure the air vents are not blocked.
ViewSonic ViewPad 1000 Tablet PC
44
Advertisement
Table of Contents
