Advertisement
Using Your Kambrook Arctic HV Floor Fan
To Operate the Floor Fan
Plug the cord into a 230V or 240V
power point and switch on.
The fan has 3 speeds.To adjust the
flow of air, turn the fan speed dial
located at the back of the fan to the
preferred speed - LOW, MED or HIGH.
To turn Off, turn the fan speed dial
to the OFF position.
notE: To avoid an electrical circuit
overload, it is recommended that
no other appliances are plugged
into the same circuit as your fan
when it is in use.
To adjust the flow of air up or down,
slightly loosen the two adjustment
knobs located on either side of the
fan and tilt the fan either upwards or
downwards to suit. Once the fan is in
the desired position, re-tighten the
two knobs to hold in place.
8
continued
Advertisement
