Basic Operation; General Functions - Kenwood KDC-BT8041U Instruction Manual

Basic Operation

[SRC] Release
AUX
Auxiliary input
(Rear side)

General functions

Power/Source Select button
Turns on the power.
When the power is ON, select a source.
SRC Select mode 1: Press the [SRC] button and then
turn the Control knob or push it toward left or right.
To determine the selected source, press the Control
knob.
SRC Select mode 2: Pressing this button each time
switches between sources.
Tuner ("TUNER") , Bluetooth audio ("BT Audio") , USB or
iPod ("USB" or "iPod"), CD ("Compact Disc") , Auxiliary
input ("AUX"), and Standby ("STANDBY")
Press at least 1 second to turn off the power.
⁄
• When the power is ON, the <Security Code> (page 20) is
displayed as "CODE ON" or "CODE OFF".
• The SRC Select mode can be set in "MENU" > "SRC Select" of
<Function Control> (page 6).
• This unit automatically turns full power OFF after 20
minutes lapses in Standby mode in order to save the
vehicle's battery. The time until full power OFF can be set in
"Power OFF" of <Function Control> (page 6).
• When connection of the iPod is recognized, the source
display changes from "USB" to "iPod".
Volume control [AUD]
Turn the knob to adjust the volume.
Attenuator [ATT]
Turning the volume down quickly.
When the volume is reduced, the "ATT" indicator
flashes.
4
| KDC-BT8041U/ KDC-BT8141U
[ATT]
[AUD]
[SRC]
Disc slot
Control knob
Faceplate release
Releases the faceplate lock so that it can be removed.
Refer to the following diagram when reattaching the
faceplate.
¤
• The faceplate is a precision piece of equipment and can be
damaged by shocks or jolts.
• Keep the faceplate in its faceplate case while detached.
• Do not place the faceplate (and the faceplate case) in areas
exposed to direct sunlight, excessive heat or humidity. Also
avoid places with too much dust or the possibility of water
splashing.
• To prevent deterioration, do not touch the terminals of the
unit or faceplate with your fingers.
Auxiliary input
Connect a portable audio device with mini-plug
cable (3.5 ø).
⁄
• Use the mini-plug cable which is stereo type and does not
have any resistance.
• The auxiliary input requires the setting made in "MENU" >
"Built in AUX" of <Function Control> (page 6).
[TI] [ ] [FNC]
USB Terminal
Release
Auxiliary input