COBRA INSTALLATION AND PROGRAMMING GUIDE
Installing the Cobra
Installing the Cobra
Installing the Cobra
1) Install the Strike Components into the Door Frame:
Insert strike box (a) into door frame.
•
Place strike (b) over strike box.
•
Secure in place with 2 screws.
•
2) Install the Cylindrical Latch:
Insert the cylindrical latch into the edge of the door.
•
NOTE: Sloped side of latch (a) should face door strike.
Secure in place with 2 screws.
•
3) Change Handing if Necessary:
Outside escutcheon is shown in figure.
Remove and retain 5/32" socket cap screw (a).
•
Remove lever.
•
Rotate lever (b) to opposite position.
•
Apply thread lock compound * to screw.
•
Reinstall screw.
•
Repeat for inside escutcheon (not shown).
•
* Loctite 242 is recomended.
•
57010-H
b
Page 4
a
b
a
a
12-19-2005