Advertisement
Maintenance
WARNING: ALWAYS DISCONNECT FROM THE MAINS SUPPLY BEFORE ATTEMPTING ANY MAINTENANCE
Access to flicker rotors and lamp replacement –
see Fig. 8
The fuel effect is secured by two screws, one at each end.
Slacken these screws (do not remove them completely) until the
fuel effect is released, then lift it clear. Ensure that the screws are
partially inserted into the fuel effect before refitting it.
Each flicker rotor should sit horizontally on its pin and spin freely
without fouling its mounting bracket. If necessary, adjust the
bracket by bending slightly (the plastic diffuser material is flexible).
To replace a lamp, bend up the defective lamp's flicker rotor top
bracket arm carefully and lift off the rotor.
Replace the defective lamp with a 60 watt B22 fuel-effect lamp.
Reassemble in reverse order, ensuring that the diffuser/top
bracket arms are positioned correctly and the flicker rotors spin
freely.
Removing the guard – see Fig. 9
Unscrew the two screws at each end of the guard, then withdraw
the lower edge of the guard first. Refit the guard in reverse order.
Removing the radiant elements – see Fig. 10
First remove the guard, as detailed above.
The element holders are spring loaded. To remove an element,
grip one end using a soft cloth to protect the surface, then push
carefully but firmly to one side until the other end disengages from
its socket. Withdraw the element carefully. Refit in reverse order.
Cleaning the reflector – See Fig. 11
The reflector may be more easily cleaned if the elements are first
removed (see above).
Wipe the reflector with a warm soapy cloth, then buff with a soft
dry cloth. DO NOT use abrasive cleaning powders or metal polish.
Cleaning
WARNING – ALWAYS DISCONNECT FROM THE POWER
SUPPLY BEFORE CLEANING THE HEATER.
Do not use detergents, abrasive cleaning powder or polish of any
kind on the body of the heater.
Allow the heater to cool, then wipe with a dry cloth to remove dust
and a damp cloth (not wet) to clean off stains. Be careful not to
allow moisture into the heater.
Specification subject to change without prior notice.
This appliance complies with European Safety Standards EN60335-2-30 and European
Standards EN55014, EN60555-2 and EN60555-3 for electromagnetic compatibility.
These standards cover the requirements of EEC Directives 73/23 and 89/336.
Glen Dimplex Heating Limited
Millbrook
Southampton
SO15 0AW
Ensure flicker rotors
rotate freely on pins and that
lamps are in sockets correctly
After Sales Service
Your appliance is guaranteed for 1 year from the date of purchase.
We undertake to repair or exchange, free of charge within the
guarantee period, any part found to be defective, excluding lamps.
Your rights under this guarantee are additional to your statutory
rights, which in turn are unaffected by this guarantee.
If your appliance is not working correctly, please contact our
Customer Helpline on 0870 727 0101.
This guarantee only applies in the United Kingdom.
UK Customer Helpline (8am-6pm Mon-Fri; 8:30am-1pm Sat.)
Tel:
0870 727 0101
Fax:
0870 727 0102
Republic of Ireland: 01 842 4833
4
Fig. 8
Fig. 9
Fig. 10
Fig. 11
T0103/004/A
Advertisement
