Advertisement
This is the easiest way to configure the Wireless AC Range Extender. Firstly,
check whether your wireless router supports WPS. For further details, please
read the operating instructions for your wireless router.
1. The mode selector must be set to the "Wireless AC Range Extender"
position for repeater mode.
2. Plug the Wireless AC Range Extender into a wall socket.
3. Press the WPS button on the Wireless AC Range Extender for at least 6
seconds. The WiFi/WPS LED should now flash for approximately 2
minutes.
4. Within these 2 minutes, press the WPS button of your Wireless AC Range
Extender for 2~3 seconds. (For further details, please read the operating
instructions for your wireless router).
The Wireless AC Range Extender will automatically connect to your wireless
router and will copy the wireless key from the settings. The Wireless AC Range
Extender can be accessed via the SSID and the wireless key of the wireless
router.
You can configure the Wi-Fi Repeater Mode by connecting it with your
computer/laptop with the enclosed RJ45 cable or wirelessly.
1. The mode selector must be set to the "Wireless AC Range
Extender" position for Repeater Mode. Plug the Wireless AC
Range Extender into a wall socket.
2. Click on the network icon ("" or "") on the right bottom of
your desktop. You will find the signal from the Wireless-AC
or Wireless-N(2.4G). Click on 'Connect', then wait for a few
seconds.
3. Open a web browser and type
your browser address box. This number is the default IP address for the
device.
Note: please check whether the Wireless AC Range Extender accords with
the factory default settings once you've entered http://192.168.10.1. If you
http://192.168.10.1
4
or
http://ap.setup
in
Advertisement
