Bosch GST Professional 135 CE Original Instructions Manual page 10

OBJ_BUCH-635-001.book Page 21 Monday, January 21, 2008 4:22 PM
Vibration total values (triax vector sum) determined
according to EN 60745:
Cutting wood:
Vibration emission value a
Uncertainty K
Cutting sheet metal:
Vibration emission value a
Uncertainty K
The vibration emission level given in this information sheet has been measured in accordance with
a standardised test given in EN 60745 and may be used to compare one tool with another. It may
be used for a preliminary assessment of exposure.
The declared vibration emission level represents the main applications of the tool. However if the
tool is used for different applications, with different accessories or poorly maintained, the vibra-
tion emission may differ. This may significantly increase the exposure level over the total working
period.
An estimation of the level of exposure to vibration should also take into account the times when
the tool is switched off or when it is running but not actually doing the job. This may significantly
reduce the exposure level over the total working period.
Identify additional safety measures to protect the operator from the effects of vibration such as:
maintain the tool and the accessories, keep the hands warm, organisation of work patterns.
Declaration of Conformity
We declare under our sole responsibility that
the product described under "Technical Data" is
in conformity with the following standards or
standardization documents: EN 60745 accord-
ing to the provisions of the directives
2004/108/EC, 98/37/EC (until Dec. 28, 2009),
2006/42/EC (from Dec. 29, 2009 on).
Technical file at:
Robert Bosch GmbH, PT/ESC,
D-70745 Leinfelden-Echterdingen
Dr. Egbert Schneider Dr. Eckerhard Strötgen
Senior Vice President Head of Product
Engineering Certification
14.12.2007, Robert Bosch GmbH, Power Tools Division
D-70745 Leinfelden-Echterdingen
Bosch Power Tools
h
h
Assembly
Replacing/Inserting the Saw Blade
Selecting a Saw Blade
An overview of recommended saw blades can
be found at the end of these instructions. Use
only T-shank saw blades. The saw blade should
not be longer than required for the intended cut.
Use a thin saw blade for narrow curve cuts.
Inserting the Saw Blade (see figure A)
If required, remove the dust cover 18 (see "Dust
Cover").
Insert the saw blade 15 (teeth in cutting direc-
tion) into the stroke rod until it latches 17.
GST 135 CE
2
m/s 6
2
m/s 2
2
m/s 6
2
m/s 1.5
Before any work on the machine itself, pull
the mains plug.
When mounting the saw blade, wear protec-
tive gloves. Danger of injury when touching
the saw blade.
1 609 929 N50 | (21.1.08)
English | 21
GST 135 BCE
5
1.5
3,5
1.5