Phonak Dynamic SoundField Installation Instructions page 4

5) Attach the power cable to the power adapter [E]. Plug the power cable
into the mains and the 19Volt jack into the socket on the bottom of
the DigiMaster 5000. Your DigiMaster 5000 is now ready to be paired
with inspiro.
Make sure the power cable is safely positioned!
3. Pairing the DigiMaster 5000 with the
inspiro
1) Take inspiro and make sure it is charged (see the Dynamic SoundField
User Guide). Switch on inspiro. If the battery symbol appears, press the
two buttons shown below-left simultaneously.
2) Release the two buttons then press OK.
4
Installation instructions
Dynamic SoundField
19V
3.2A AUDIO
19V
3.2A AUDIO
3) You will now see the inspiro installer menu. Select "Pairing". inspiro
will now guide you through the pairing process. Please follow the
instructions provided:
a) When you see three dots on the inspiro LCD, hold inspiro close
to the loudspeaker (nearer than 1 meter / 3 feet) and switch on the
DigiMaster 5000.
19V
3.2A
19V
3.2A AUDIO
b) After a short time, inspiro will inform you that the loudspeaker
has been paired. The LED color of the DigiMaster 5000 will now
display a constant blue light. This blue light shows that the
Dynamic SoundField system is ready for operation.
4) If not required immediately switch off both inspiro and the
DigiMaster 5000. Dynamic SoundField's installation is complete.
Please check the Dynamic SoundField User Guide to learn
about the standard functionality of Dynamic SoundField.
AUDIO