Volume Offset; Crossover Network Control Setting; High-Pass Filter Frequency For Front Output - Kenwood Z920DVD Instruction Manual

13.Volume Offset

Set the sound level of the each source selected by adjusting
the level difference between the basic sound level and the
required level.
Display and setting:
"Volume Offset" : - 8 – ± 0

Crossover Network Control Setting:

Adjust various parameters of sound quality.
1
Hold down the XOVER button for one second or more to enter
the control mode.
2
Selecting mode
Press either the FM or AM button.
Each time the button is pressed, the adjustment mode will
change.
Please refer to the following for the contents of the adjustment
modes. (Items 1-4 can be adjusted in this Adjustment mode.)
3
Adjust each mode
Press the 4/¢ button.
Please refer to the following for the adjusting values.
4
Press the XOVER button for one second or more to end the
control mode.

1.High-pass Filter Frequency for Front Output

Adjust the frequency of the High-pass filter for front output.
Display and setting:
"FRNT HPF" : THROUGH / 40Hz / 60Hz / 80Hz / 100Hz / 120Hz
/ 150Hz / 180Hz / 220Hz
NOTE
You can separately set the high-pass filter for front and rear
output, including preouts. The high-pass filter does not affect the
non-fading preout.
— 21 —