Table of Contents
Advertisement
eyAMAHIf-----
YHI-24
QUICK-CONNECT GUIDE
PROGRAMMING THE UNIVERSAL REMOTE CONTROL (CONTINUED)
SETTING
Up
YOUR CABLE
Box
(OR DSS)
1.
Turn on the cable box (or DSS) and look up a setup
code for your brand of cable box (or DSS) (codes are
located at the back of the HTR-5440 Owner's Manual.
2. On the remote control, press CBL/SA
T.
3. Press and hold both VOLUME buttons at least four
seconds until the indicator LED flashes twice.
4. Using the keypad, enter the four-digit setup code.
The indicator LED will flash twice after your entry.
If the LED did not flash twice, repeat steps 3 and 4.
5. To verify the code works, aim the remote control at
the cable box (or DSS), press CBL/SAT, and then
press POWER. The unit should turn off. If it doesn't
respond, use another code for the same manufac-
turer and repeat steps 3 through 5.
SETTING
Up
YOUR VCR
1.
Turn on the VCR and look up a setup code for your
brand of VCR.
2. On the remote control, press VCR.
3. Press and hold both VOLUME buttons at least four
seconds until the indicator LED flashes twice.
4. Using the keypad, enter the four-digit setup code.
The indicator LED will flash twice after your entry.
If
the LED did not flash twice, repeat steps 3 and 4.
5. To verify the code works, aim the remote control at
the VCR, press VCR, and then press POWER. The
VCR should turn off. If it doesn't respond, use
another code for the same manufacturer and repeat
steps 3 through 5.
SETTING
Up
OTHER COMPONENTS
1.
Turn on the component (e.g., CD player, tape deck,
or MD player) and look up a setup code for your
brand of component.
2. On the remote control, press the desired component
button (e.g., CD or TAPE/MD).
3. Press and hold both VOLUME buttons at least four
seconds until the indicator LED flashes twice.
4.. Using the keypad, enter the four-digit setup code.
The indicator LED will flash twice after your entry.
If the LED did not flash twice, repeat steps 3 and 4.
5. To verify the code works, aim the remote control
at the component, press the appropiate compo-
nent button, and then press POWER. The unit
should turn off. If it doesn't respond, use another
code for the same manufacturer and repeat steps 3
through 5.
Advertisement
Table of Contents
