Connecting Wires To Terminals - Kenwood KVT-536DVD Installation Manual

Connecting Wires to Terminals

Ignition key
switch
Car fuse box
(Main fuse)
+
–
Battery
Connect to the vehicle's parking brake detection
switch harness.
Connect to vehicle's reverse lamp harness when
To use the steering wheel remote control feature,
you need to an exclusive remote adapter (not
supplied) matches your car is required.
Connect to the terminal that is grounded when either
To connect the Kenwood navigation system,
consult your navigation manual.
Depending on what antenna you are using, connect either to the control
terminal of the motor antenna, or to the power terminal for the booster
amplifier of the film-type or short pole type antenna.
4
|
KVT-536DVD/KVT-536DVDM
ACC
Ignition wire (Red)
Battery wire (Yellow)
Car fuse box
Ground wire (Black)- (To car chassis)
For the sake of safety, be sure to connect the parking sensor.
PRK SW
using the optional rear view camera.
To car light control switch
To steering remote
the telephone rings or during conversation.
When using the optional power amplifier,
connect to its power control terminal.
If no connections are made, do not let the cable come out from the tab.
USB device
(commercially available)
If you connect the ignition wire (red) and
the battery wire (yellow) to the car chassis
(ground), you may cause a short circuit, that
in turn may start a fire. Always connect those
wires to the power source running through
the fuse box.
FUSE ( 15A )
Parking sensor wire (Light Green)
Reverse sensor wire (Purple/White)
Dimmer control wire (Orange/White)
Steering remote control input (Light Blue/Yellow)
Mute wire (Brown)
Motor antenna control wire (Blue)
Power control wire (Blue/White)
USB connector