Sony 158SVR2000 Setup Manual page 52

Note
If you have your stereo hooked up to your
TV, you can program the Remote Control's
VOL (volume) and MUTING buttons to send
signals to your stereo rather than to your TV.
Go to "Messages & Setup", then "SVR
Remote Setup", then "SVR Remote - TV"
Press the TiVo and VOL buttons to
illuminate the LED before you enter the
code.
521
Programming Your Remote Control
4
Enter the Remote Control code.
When you select your TV brand, you will see a screen wIth one or more four-digIt
codes for your TV
a) Cover the end of the Remote Control wIth your hand to shIeld the IR EmItter.
b) On the Remote Control, press and hold the TiVo and TV POWER buttons
sImultaneously for about three seconds, until the remote's LED illummates.
Release the buttons and the LED will remam illummated.
c) Use the number keys on your Remote Control to enter the four-digIt code you
want to test (start wIth the first code m the list on the screen).
d) After pressmg the fourth digIt of the code, the LED will flash three tImes,
mdicatmg that you entered a valid code.
e) Test the code by pomtmg your Remote Control m the directIon of the TV and
pressmg the TV POWER button. If thIS turns the TV off, you have found the
correct code. Now you can use the Remote Control to tum your TV on and off,
control volume, and mute the sound.
f) If the Remote Control could not tum your TV off, try the next code listed for
your TV