The Mon Setting (Monitor Mode); Using The Lcd Panel - Test-Um Lil' Buttie Ranger User Manual

Telephone test set with amplified speaker
Table of Contents

Advertisement

Lil' Buttie RANGER
or FAIL depending on the correctness of the received
data. If you leave the TALK/BELL/MON switch in this
position when the Ranger is ringing, nothing will happen
and the Ranger will power OFF again about 30 seconds
after the end of ringing.

4.1.3 The MON Setting (MONITOR Mode)

The MON position (MONITOR mode) causes the
Ranger to enable its amplifiers so that you can listen
to a line without loading it. On-hook Caller ID is also
received, checked and displayed in this mode. In the
first minute of entry to MONITOR mode, if there is
no Caller ID or DTMF information on the screen, the
Ranger measures its battery voltage and estimates the
remaining battery capacity. On line 2, it displays the
time remaining to automatic power-off, the measured
line voltage, and the polarity. The Ranger also monitors
the line it is connected to for DTMF signals. If it detects
any of the 16 valid DTMF signals, it will display up to
32 characters, and keep them on the LCD regardless
of changes in the state of the monitored line.
20

4.2 Using the LCD Panel

The Ranger has a reflective type, super twisted liquid
crystal display (LCD). The display has 2 lines of 16
alphanumeric characters each, plus a number of icon
flags. The icons are used and defined as follows:
• Steady ID indicates displayed data is Caller ID
information.
• Flashing ID indicates Call Waiting Caller ID
(CWCID) detection is enabled. Enabling CWCID
is an option in the setup menu (see Section 4.6).
• PASS appears with ID to indicate that Caller ID
information was received with no errors detected.
• FAIL appears with ID to indicate that Caller ID
information was received with errors. An error
message will also be displayed.
• SETUP indicates that the Ranger is in SETUP
mode.
• 1 through 8 indicate which stored phone number
slot you've selected.
• A battery icon indicates that the Ranger's battery
needs to be replaced.
• A "no bell" icon indicates that the Ranger is in
MONITOR mode and that the bell (ringer) is off.
CHAPTER 4: Operation
21

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Lil' buttie ranger lb250

Table of Contents