Security Code Setup - Kenwood DDX7015 Instruction Manual

Setup Menu

Security Code Setup

You can set a security code to protect your
receiver system against theft.
When the Security Code function is activated, the
code can't be changed and the function can't be
released.
Note, the Security Code can be set as the 4 digit
number of your choice.
1 Display the Security Code Setup screen
Set Up
If Set Up is not shown, touch or
to display it.
3
M e n u S e c u r i t y C o d e
S e t
Audio
2
Set Up
S I On O f f
SRC
1
Se c u r i t y
1 Returns to the Control screen of the previous
source.
2 Calls the Sound Effects Menu. (see page 84)
3 Calls the Setup Menu.
4 Allows you to start security code registration.
If you have already completed the code
registration, the is not displayed.
S e t
78 English
2 Start the security code registration
S e t
Pa s s Wo r d
1 * * * *1 s t
1 2 3
4 5 6
8
7 9
0
2
3
C l e a r C a n c e l
1 Enters a security code.
2 Clears your entry.
3 Cancels the registration and returns to the
Security Code Setup screen.
4 Enters the security code.
4
3 Enter a security code
—
0 9
Input a four-digit number.
4 Register your security code
E n t e r
5 Reenter the security code
Reenter the same security code as that you have
entered in Step 3 for confirmation.
If you enter a different security code, the screen
returns to Step 3 (for the first code entry).
6 Register the security code again
E n t e r
Your security code has been registered.
If you press the Reset button or if you disconnect
your Receiver from the battery after the code
registration, you need to enter the registered
security code.
See below for details.
If you have pressed the Reset button or if you
have disconnected the Receiver from battery...
1 Enter the correct security code
0
You must enter the same security code as that you
have entered in Step 3 above.
2 Enter the security code
4
E n t e r
E n t e r
Now, you can use your Receiver.
—
9
English 79