CNXQ Flat-panel Ceiling Speaker Installation Instructions for
CAT 800 Series
Speaker Installation (Continued)
Step 3: Connecting the Speaker Wire to the Amplifier
a. Unplug the euro-block SPEAKER OUTPUT connector from the
amplifier.
b. Insert the two wires into the connector, paying close attention to
polarity (+ - - +).
c. Insert the red (+) wire and black (-) wire from the speaker into the left
side of the connector (SPEAKER OUTPUT 1). Tighten the screw on
top of the connector with small screwdriver to secure.
d. Plug the euro-block connector back into the amplifier and secure
using the two side screws.
NOTE: If connecting to CAT 885 the corresponding speaker volume
should be set in the maximum position.
Step 4: Return to the Set-up and Use section of the product User
Manual to continue installation.
Figure 4: Connecting Speaker Wire to Back of Amplifier
CAT 885
CAT 855