Operating Instructions - Clarke ENCORE MAX Operator's Manual & Parts List

OPERATING INSTRUCTIONS

PRE-START CHECKLIST
1. Check controls for proper operation.
2. Make sure all controls are in the off position
3. Be sure foot throttle is in the neutral position
4. Check all flaps for damage or wear
5. Check scrub brushes for wear
6. Fill solution tank with water and detergent
TO FILL SOLUTION TANK
Remove the solution lid located on the back right side of the machine as shown in figure 30. Fill tank with 40
gallons of water and the correct mixture of American Lincoln Commercial cleaner for the job on hand, first
making sure that the solution control knob is "OFF." Place the lid back on the solution tank.
TO START MACHINE
1. Release secondary parking brake (if equiped).
2. Turn key to "I" position.
TO TRANSPORT MACHINE
1. Make sure the brushes and squeegees are in the up or raised position with all other controls in the off
position.
2. Push the forward/reverse switch to desired position (up for forward and down for reverse)
3. Push down on the foot throttle to obtain desired travel speed, release foot throttle to stop.
Do not turn the steering wheel sharply when the machine is in motion. The sweeper is very
responsive to movement of the steering wheel. Do not make sudden turns.
1-30
Note
Before starting, perform the pre-start checks.
SOLUTION TANK
RECOVERY TANK
Fig. 30
WARNING
CLARKE
ENCORE MAX