Connecting Cables To Terminals - Kenwood KRC-PS979R Instruction Manual

Connecting Cables to Terminals

Connector Function Guide
Pin Numbers for
Cable Colour
ISO Connectors
External Power
Connector
A–4 Yellow
A–5 Blue/White
A–6 Orange/White
A–7 Red
A–8 Black
Speaker
Connector
B–1 Purple
B–2 Purple/Black
B–3 Gray
B–4 Gray/Black
B–5 White
B–6 White/Black
B–7 Green
B–8 Green/Black
FM/AM
antenna input
Functions
Rear left
output (White)
Battery
Power Control
Dimmer
L
Ignition (ACC)
Earth (Ground)
R
REAR FRONT
Connection
Front right
output (Red)
+
Rear Right ( )
Rear right
–
Rear Right ( )
output (Red)
+
Front Right ( )
Fuse(10A)
–
Front Right ( )
+
Front Left ( )
–
Front Left ( )
+
Rear Left ( )
–
Rear Left ( )
Battery cable (Yellow)
Ignition cable (Red)
A–7 Pin (Red)
A–4 Pin (Yellow)
Connector A
Connector B
Antenna Cord (ISO)
Antenna Conversion Adaptor (ISO–JASO) (Accessory3)
Front left
output (White)
Wiring harness
(Accessory1)
External amplifier control cable
(Pink / Black)
TEL mute cable (Brown)
Power control/ Motor antenna
control cable (Blue/White)
8 6 4 2
NOTE
7 5 3 1
If no connections are
8 6 4 2
made, do not let the cable
7 5 3 1
come out from the tab.
— 46 —
Non-fading right output (Red)
Non-fading left output (White)
To KENWOOD disc changer/
DAB control input/
KPA-SD100/KPA-HD100/KPA-SS100
NOTE
To connect these leads, refer to the
relevant instruction manuals.
To "EXT.AMP.CONT." terminal of the
amplifier having the external amp
EXT.CONT.
control function.
Connect to the terminal that is
grounded when either the telephone
TEL MUTE
rings or during conversation.
NOTE
To connect the KENWOOD navigation
system, consult your navigation manual.
Connect either to the power control
terminal when using the optional
P.CONT
power amplifier, or to the antenna
ANT.CONT.
control terminal in the vehicle.