gio Vyper 4WD 1100cc 2 seater Owner's Manual page 61

Engine Oil
Oil and Filter Change
Always change the oil and filter at the intervals outlined in the Periodic Maintenance Chart beginning on page49.Always
change the oil filter whenever changing oil.
The engine drain plug is located on the bottom of the crankcase.
1. Position the vehicle on a level surface. Set the parking brake.
2. Start the engine. Allow it to idle for two to three minutes, Stop
the engine.
3. Clean the area around the drain plug.
CAUTION: Hot oil can cause burns to skin. Do not allow hot oil
to contact skin.
4. Place a drain pan under the engine crankcase.
5. Remove the drain plug. Allow the oil to drain completely.
NOTE: The sealing surfaces on drain plug and crankcase
should be clean and free of burrs or scratches.
6. Using a cap-style oil filter wrench, turn the oil filter cartridge to
remove it.
7. Using a clean dry cloth, clean the filter sealing surface on the crankcase.
8. Lubricate the o-ring on the new filter with a film of fresh engine oil.
Check to make sure the o-ring is in good condition.
1100cc:
800cc:
53
MAINTENANCE