Table of Contents
Advertisement
Menu settings
Brightness level adjustment
You can adjust the brightness level of the unit separately when
your car's light switch has been turned on or off.
Display and setting:
"Bright 0" – "Bright 10"
NOTE
The initial setting value whilst your car's light switch is turned on
is "5" , and whilst the light is turned off is "10" .
Dimmer
You can dim the display.
NOTE
The dimmer function is not available for units if the dimmer cable
is not connected.
Display and setting:
"Dimmer ON" : The dimmer setting is on.
"Dimmer OFF" : The dimmer setting is off.
Switching Graphic Display
You can turn the movement of graphic display on and off.
The initial setting is ON.
Display and setting:
"Graphic ON" : The graphic display works.
"Graphic OFF" : The graphic display does not work.
Black Mask
This function allows you to turn off the graphic part of the
display if there is too much information in the display.
Display and setting:
"BLACK MASK ON" : The display will be shown in horizontally
"BLACK MASK OFF" : The display will turn on by using the
NOTE
This function cannot be set in the full-screen display and
horizontal division display.
Time setting for removing the faceplate
You can set the interval during which the open control panel
cannot reverse to be hidden. During the period you have set,
the faceplate can be removed from the faceplate bracket.
Display and setting:
"OFF WAIT" : 0sec / 3sec / 5sec / 10sec / 15sec / 20sec /
25sec (sec=sec.)
NOTE
If you do not slide the faceplate lock switch during the period
which you have set, the unit's power turns off after the control
panel is automatically hidden.
Dual Zone System
The following operation allows separate sound sources to
control the output of the front and rear speakers. The Dual
zone system can only be switched on or off when the source is
set to the AUX mode.
Display and setting:
"Zone 2 ON" : The dual zone system function is on.
"Zone 2 OFF" : The dual zone system function is off.
NOTE
— 34 —
divided mode. When this function is
enabled, the dual display mode is entered
and ••• (MD-IN) indicator is displayed.
Clock alone is displayed in the lower part.
whole part of the display.
Advertisement
Table of Contents
