Placing Blender Into Operation; Removing Contents - Bosch MUM 6N10 UC Use And Care Manual

4. Place the blender with cover on the
high-speed drive of the power unit.
Note the mark on the appliance and
on the blender. Turn the blender
counterclockwise with a slight
downward pressure until the jar is
firmly seated, see figure 13.
Figure 13
Placing Blender into
Operation
Normally when blending, the blender jar
should be filled with the entire amount of
material to be blended, if possible, before
switching the appliance on. The cover and
cover closure should always be in place
after filling the blender jar and before
switching the power unit to On.
Any subsequent additions to the blended
material should be made through the cover
opening, see figure 14.
For solids and/or granular material, remove
the cover closure/funnel to add the material,
as shown in figure 14a.
For liquids, the closure/funnel may be left in
place and the liquids added by pouring it
into the closure/funnel, see figure 14b.
Figure 14

Removing Contents

Before beginning to remove the contents
from the blender, make sure that the power
unit has been turned to the Off position,
"0/off". Remove the blender from the power
unit by turning the blender clockwise while
lifting. With the blender removed from the
power unit, the contents of the blender may
now be poured into a suitable container or
bowl, as desired.
21