Product Identification; Local Codes - Desa A Series Owner's Operation And Installation Manual

PRODUCT
IDENTIFICATION
Middle Log
Front Log
Front
Burner
Figure 1 - Log Base Assembly, Split Oak Set
Top Louver
Assembly
Fireplace
Hood
Firebox
Support
Screen
Assembly
Figure 2 - Fireplace
104410
Crossover Log
Base Assembly
Bottom Louver
Assembly
OWNER'S MANUAL

LOCAL CODES

Install and use fireplace with care. Follow all
local codes. In the absence of local codes, use
the latest edition of The National Fuel Gas
Rear Log
Code ANS Z223.1, also known as NFPA 54*.
*Available from:
American National Standards Institute, Inc.
National Fire Protection Association, Inc.
Rear
Burner
UNPACKING
1.
Top Outer
Casing
2. Locate two screws above top corners
3.
4. Remove fireplace hood from carton
5. Check all items for any shipping dam-
Blower Assembly
(Models VSGF28PTC and
CSG28PTC Only, Optional
for Model VSGF28PVA)
3
1430 Broadway
New York, NY 10018
Batterymarch Park
Quincy, MA 02269
WARNING: Do not remove
the metal data plates attached to
the heater base assembly. The
data plates contain important
warranty information.
With utility knife, cut the carton all the
way around above the staples on the
bottom tray. Lift the carton off the
heater. Remove packing. Note: The
hood is located in the packing on the
right hand side of the heater front. Lift
the heater off the bottom tray.
of the fireplace screen. Remove and
discard these screws. Lift fireplace
screen up and pull out to remove.
Remove protective packaging applied to
logs, log base assembly, and fireplace.
insert.
age. If damaged, promptly inform
dealer where you bought fireplace.