Pride Mobility Go-Chair Owner's Manual page 24

V . C O M F O R T
NOTE: If the lever will not rotate to the fully closed
position, then turn the nut anticlockwise one-quarter
or one-half turn.
Armrest Width Adjustment
You can change each armrest's width independently of the other.
NOTE: Changing the armrest width may increase the
overall width of your Go-Chair.
To change the armrest width:
1. Locate the two armrest knobs on each side of the arm-
rest receiver bracket. See figure 18.
2. Loosen the knobs.
3. Remove the detent pins.
4. Slide the armrests in or out to the desired width.
5. Reinstall the pins and tighten the knobs.
Foot Platform Depth Adjustment
To adjust the foot platform depth:
1. Remove the hardware from the footplatform bracket.
See figure 19.
2. Move the foot platform in or out to the desired depth.
3. Reinstall the hardware into the foot platform bracket
and tighten.
Controller Position
You can position the controller for either left-hand or right-
hand use.
WARNING! Do not place the controller
cable so that it can be pinched in the
seat frame or the power base frame.
To change the controller position:
1. Turn off the power to the controller.
2. Unplug the controller connector from the power base.
3. Cut all wire ties securing the controller cable to the
armrest.
4. Flip up the armrest and loosen the setscrew. See figure 20.
5. Slide the controller out of the armrest.
6. Loosen the setscrew in the other armrest.
7. Place the controller in the other armrest.
8. Tighten the setscrew in each armrest.
9. Use a wire tie to secure the controller cable to the armrest.
10. Plug the controller connector into the power base.
24
A D J U S T M E N T S
ARMREST KNOB
(LOCATED ON
SEAT FRAME)
Figure 18. Armrest Width Adjustment
Figure 19. Foot Platform Depth
Figure 20. Controller Position
www.pridemobility.com
DETENT
PIN
SETSCREW
Go-Chair