Pride Mobility Go-Chair Owner's Manual page 21

I V . A S S E M B L Y / D I S A S S E M B L Y
Seat Installation
It may be necessary to install the seat either prior to initial op-
eration or after transporting your Go-Chair. The seat is attached
to the power base by a height-adjustable seat pedestal.
WARNING! Do not pick up the seat frame
by the armrests. They are free to pivot,
and you may lose control of the seat if
they do so.
To install the seat:
1. Adjust the seat height if necessary. See V. "Comfort Ad-
justments."
2. Set the seat onto the seat pedestal. See figure 9.
3. Install the controller into the armrest, and tighten the set-
screw under the armrest.
4. Plug the controller connector into the power base. See
figure 6.
MANDATORY! Prevent controller harness
damage! Avoid routing the controller
harness on the outside of the armrest pad.
Route the harness under the armrest or
toward the inside of the armrest pad. Use
correct tie-down points for the controller
harness to prevent the harness from getting
caught in the drive tyres, pinched in the seat
frame or damaged when passing through
doorways.
Disassembly
The Go-Chair disassembles into four components: the seat, the
battery box, the rear section of the power base and the front
section of the power base. See figure 10.
To disassemble the Go-Chair:
1. Turn off the power to the controller.
2. Place the Go-Chair in drive mode. See III. "Your Go-Chair."
3. Disconnect the controller from the power base.
4. Remove the seat.
5. Grasp the battery box handle and lift up to disengage the
box from the power base, then tilt the box forward slightly
and pull it away from the power base.
6. Push in the toggle latch release button while pulling forward
on the toggle latch. See figure 11.
7. Rotate the toggle latch buckle over the top of the toggle
latch until it snaps into its retainer. See figure 12.
8. Lift the front section up and off of the rear section.
Go-Chair
Figure 9. Seat Installation
Figure 10. Go-Chair Components
www.pridemobility.com 21