Kenwood KDC-MP4026V Instruction Manual page 26

Installation
Screwing the Faceplate on the Unit
If you want to fasten the faceplate to the main
unit so that it does not fall off, screw in the
provided screw in the holes shown below.
Accessory5
• Never insert the screw in any other screw hole than the
one specified. If you screw them in another hole, it will
contact and may cause damage to the mechanical parts
inside the unit.
26
|
English
Using the Relay Connector
1
Plug the vehicle's harness into the relay
connector.
2
Plug the parking brake detection wire into the
relay connector.
Vehicle harness
1
Detection wire
3
Lock the cable clamp.
Cable clamp
4
Press down using pliers until the conductive
metal is even with the plastic surface.
5
Lock the lid.
Lid
Relay connector
Accessory7
2
3
5
4
Conductive metal