Advertisement
7. AC line fuse
DC cable fuse
8. Charge output
9. Battery types
10. Temperature range
11. Weight for one charger
12. Dimensions for the charger
13. Degree of protection moisture
and water.
14. EMC
15. LVD (Electrical safety)
16.
42406302.doc
T4AH-250V (4A Slow, 5x20 mm, ceramic type)
Located at the side of the charger
The charger does not have any DC-supply fuse. The
charger is only allowed to be connected to a fused
DC-supply. A fuse for the charger must be located in
the wiring of the vehicle. A DC supply cable is
available from Natek with an 8A slow (T8AL-250V),
5x20mm standard glass type fuse inside its vehicle
connector. Refer to chapter: DC supply cable, Fuse
replacement
Max possible nominal charge voltage 36 VDC
Max battery detection voltage 37 VDC
4 channels. Max 250W output power
ML314B: 8A out (2A per channel)
ML314B-4A: 16A out (4A per channel)
Charging voltage accuracy: ±1%,
Charging current accuracy: ±10%
Only rechargeable batteries of the type dedicated to
be used by the specific battery adapter fitted to the
charger may be connected to the charger.
Operating: - 40°C to + 55°C, The charging current
might be reduced at high ambient temperatures.
Storage: - 55°C to + 70°C
6.8 kg Without battery adapter and cables
153 x 110 x 330 (WxHxL)(H with battery adapter on
top of the charger)
IP68 / 1meter
Emission
EN 61000-6-4
Immunity
EN 61000-6-2
Immunity
EMP-Pulse acc. MIL-STD-461D:
Refer to EC/EEA Declaration of Conformity,
document for environmental endurance tests.
EN60335-1, EN60335-2-29
The charger is CE-marked
2008-10-17
Page: 5 (5)
Advertisement
