Audio Adjustments; Audio Control; Audio Setup - Kenwood KDC-BT7539U Instruction Manual

Audio Adjustments

Audio Control

You can adjust following Audio Control items ;
Adjustment Item Display
Rear volume "REAR VOLUME" 0 — 35
Subwoofer level "SUB-W LEVEL"
System Q "USER"/"ROCK"/
"POPS"/"EASY"/
"TOP40"/"JAZZ"/
"NATURAL"
Bass level* "BASS LEVEL"
Middle level* "MIDDLE LEVEL" –8 — +8
Treble level* "TREBLE LEVEL"
Balance "BALANCE"
Fader "FADER"
Exit Audio Control mode (Volume control mode)
* Source tone memory: Puts the set up value in the
memory per source.
⁄
• "USER": The ranges selected lastly for Bass level, Middle
level, and Treble level are recalled automatically.
1
Select the source to adjust
For how to select source item, refer to <Power/
Source Select button> of <Basic Operation> (page
4).
2
Enter Audio Control mode
Press the [AUD] knob.
3
Select the Audio item to adjust
Press the [AUD] knob.
4
Adjust the Audio item
Turn the [AUD] knob.
5
Exit Audio Control mode
Press any button.
Press a button other than the [AUD] knob or [0]
and [ATT] button.
Range
–15 — +15
User setting/Rock/Pops/Easy/
Top 40/Jazz/Natural
–8 — +8
–8 — +8
Left 15 — Right 15
Rear 15 — Front 15

Audio Setup

You can set Sound system , such as follows;
Adjustment Item Display
Front High Pass Filter "HPF-F"
Rear High Pass Filter "HPF-R"
Low Pass Filter "LPF"
Subwoofer Phase "SW PHASE"
Volume offset "VOL-OFFSET"
Loudness "LOUD"
Dual Zone System "2 ZONE"
⁄
• Volume offset: Sets each source's volume as a difference
from the basic volume.
• Loudness: Compensates for low and high tones during
low volume. (Only the low tone is compensated for
when the tuner is selected as a source.)
• Dual Zone System
Main source and sub source (Auxiliary input) output
Front channel and Rear channel separately.
- Set up the channel of sub source by "Zone2" of
<Function Control> (page 6).
- Select Main source by [SRC] button.
- Adjust the volume of Front channel by [AUD] knob.
- Adjust the volume of Rear channel by <Audio Control>
(page 19) or [5]/[∞] button on the remote control
(page 28).
- The Audio Control has no effect on sub source.
1
Select the source to adjust
For how to select source item, refer to <Power/
Source Select button> of <Basic Operation> (page
4).
2
Enter Audio Setup mode
Press the [AUD] knob for at least 1 second.
3
Select the Audio Setup item to adjust
Press the [AUD] knob.
4
Adjust the Audio setup item
Turn the [AUD] knob.
5
Exit Audio Setup mode
Press the [AUD] knob for at least 1 second.
Range
Through/40/ 60/80/100/120
/150/180/220 Hz
Through/40/ 60/80/100/120
/150/180/220 Hz
50/60/80/100/120/Through
Hz
Reverse (180°)/ Normal (0°)
–8 — ±0 (AUX: -8— +8)
OFF/ON
OFF/ON
English
19
|