Kenwood KDC-3028 Instruction Manual page 31

Screwing the Faceplate on the Unit
If you want to fasten the faceplate to the main
unit so that it does not fall off.
1
Refer to the section <Removing the hard rubber
frame> (page 32) and then remove the hard
rubber frame.
2
Drop open the faceplate by pressing the Release
button.
Tighten the stepped screw (Accessory 5) in the
3
hole shown on the diagram.
Accessory5
Tighten the screw (ø2 × 5 mm) (Accessory 6)
4
and bracket (Accessory7 ) in the hole shown on
the diagram.
Accessory7
Accessory6
Tighten the screw (ø2 × 5 mm) (Accessory 6)
5
and bracket (Accessory8) in the hole shown on
the diagram.
• Never insert the screws in any other screw hole than the
one specified. If you screw them in another hole, it will
contact and may cause damage to the mechanical parts
inside the unit.
Accessory5
Accessory6
Accessory8
Accessory6
..........1
..........2
31
|
English