Installation - MacroSystem Digital Video Claro Supplementary Manual

8
If you want to connect a television and it
supports the YC signal, please use the S-VHS
output on the Casablanca Claro. If the TV does
not support the YC signal, connect the television
to the CVBS connection on the Casablanca
Claro. If your television only has SCART inputs,
please use the supplied SCART adapter (see
connection diagram). We recommend you
connect the adapter to the S-VHS connection of
the Casablanca Claro if your television's SCART
socket supports the YC signal (you will find this
information in the operating manual for your
television set).
If you use the adapter, you will also need to use
the supplied audio adapter cable to connect the
"line out" output to the SCART adapter.
Please make sure that the selector switch on the
adapter is set to the "Input" position.
Important notice: Never disconnect a cable
from the Casablanca Claro while the system
is switched on! You must always switch the
system off before disconnecting or connecting
any cables!

3. Installation

The Casablanca Claro system allows you to
install the system software and add-on software
from a CD/DVD. It is not possible to install
software from a SmartMedia card. The card
reader can only be used to access photos stored
on memory cards.
It is possible that the supplied SMART EDIT
version on the CD/DVD is more up-to-date than
the version already installed on the system.
To check whether this is the case, first switch on
the device by pressing the power-on button. The
Casablanca Claro logo then appears followed
by the main menu. You can compare the
version number on the CD/DVD with the version
number shown in the bottom left of the "System
settings" menu.
If a current version is already installed on your
system you can start editing right away.
If your system does not start immediately,
please inquire with your dealer.
Updating the system software
If the version number on the CD/DVD is higher,
you should install this version. Proceed as
follows:
You are still in the "System settings" menu.
Click on the "Install product" button and then
open the CD/DVD drive by pressing the button
below the drive. Next, insert the CD/DVD and
select the "Smart Edit" software. Since the CD/
DVD also contains the complete range of add-on
software currently available for the Casablanca,
you will also see a whole list of programs
displayed.
Note: Please note that it can take several
minutes before the list of programs is displayed.
After you select the system software, click on
"activate". The data are then copied and the
system prepares to carry out the installation.
After the progress bar disappears, a message is
displayed informing you that the system is now
ready to restart. After you confirm this message
with "Ok", the system might ask you to enter
the license code (only if a new version is being
installed, for instance, when upgrading from
SMART EDIT 3.6 to 4.0).
Please make sure you enter the correct code!
Once you have entered the correct license
code and closed the window by pressing "Ok",
you should also confirm the "Install product"
window by clicking on "Ok". The system will
then ask you to remove the CD/DVD. Once you
have removed it by pressing on the drive's
button, the system restarts automatically and
the actual installation process begins:
• If you want to install an update (e.g. SMART
EDIT 4.0 to 4.1), please proceed as follows:
first of all, select the installation language. A
message will then appear informing you that
your projects will remain intact during and after
the installation. You will be asked whether you
want to carry out the installation. If you click on
"Yes", the software will be updated.
If you want to completely reinstall the software,
click on "No" (bear in mind that if you choose
this option all the project data stored on the
system will be lost) . You are then given the
option of canceling the operation ("No") or
carrying out the completely new installation
("Yes").