Introduction - Gearmore FM-60 Operation, Service & Parts Manual

We welcome you as an owner of a Gearmore mower. Please read the
following instructions and refer to them when required.
This manual contains valuable information about your new Gearmore
Mower. It has been carefully prepared to give you helpful suggestions
for operating, adjusting, servicing and ordering repair parts.
Keep this manual in a convenient place for quick and easy reference.
Study it carefully. You have purchased a dependable and sturdy mower,
but only by proper care and operation can you expect to receive the service
and long life designed and built into it.
Sometime in the future your mower may need new parts to replace those
that are worn or broken. If so, go to your dealer and provide him with the
model and part number.
CAUTION NOTE:
BEFORE PUTTING MOWER INTO SERVICE
1. Fill gearbox with 90 to 140 weight gear oil. Fill through
to / " pipe plug hole.
1
8
2. Fill all (3) spindle units with grease until full. There are (3) grease access
holes for greasing spindle units in top cover.
3. Grease all wheel axles, wheel forks, front roller axle, and PTO shaft.
4. Check air pressure in tires, maintain rated psi listed on the tire at all
times.
5. Check all nuts, bolts and belts to insure they are tight and secure.
NOTE: Grease every 8 hours

INTRODUCTION

This mower is designed for and must be operated
with a 540 rpm PTO.
/ " pipe plug hole
1
2
Page 1