Acer Aspire 2010 Service Manual page 47

LCD
Item
Suspend/Standby control
Electrical Specification
Supply voltage for LCD
display (V)
Supply voltage for LCD
backlight (Vrms)
AC Adapter
Item
Vendor & model name
Input Requirements
Maximum input current (A,
@100Vac, full load)
Nominal frequency (Hz)
Frequency variation range
(Hz)
Nominal voltages (Vrms)
Inrush current
Efficiency
Output Ratings (CV mode)
DC output voltage
Noise + Ripple
Output current
Output Ratings (CC mode)
DC output voltage
Constant output
Dynamic Output Characteristics
Start-up time
Hold up time
Over Voltage Protection
(OVP)
Short circuit protection
Electrostatic discharge
(ESD)
Dielectric Withstand Voltage
Primary to secondary
Leakage current
Regulatory Requirements
Chapter 1
Yes Yes
3.3 3.3
690 690
Delta ADP-65DB
Liteon PA-1650-02CR
1.5A max@3.5A/100Vac and 240 Vac
47 - 63
47 - 63
90 - 264
The maximum inrush current will be less than 50A and 100A when
the adapter is connected to 100Vac(60Hz) and 240Vac(50Hz)
respectively.
High efficiency 85% minimum, at 100~240Vac AC input, full load,
warm-up condition.
Offers constant voltage 19.0V output source with 65W max output
power capacity.
300mvp-pmax (20MHz bandwidth) for resistor load
0 A (min.) 3.5A (max.)
18.0 ~ 20.0
3.5A
3 sec. (@115 Vac and 230Vac full load)
5ms min. (@115 Vac input, full load)
25V
Output can be shorted without damage, and auto recovery
15kV (at air discharge)
8kV (at contact discharge)
4242 Vdc for 1 second
60uA at 240Vac/60Hz
1. FCC class B requirements (USA)
2. VDE class B requirements (German)
3. VCCI classII requirements (Japan)
Specification
Yes
3.3
690
Specification
Yes
3.3
690
39