Advertisement
II
22.24.
44.
-15.
;
00 0
0000
3 0 000
000
0000;
'8
00000000f00
Numbers
correspond
to steps.
electrical
Shock Hazard
Take special care when drilling
holes into the wall. Electrical
wires may be concealed behind the
wall covering and contact with
them could result in
eleCtriCal
shock.
8
Drill a l/Z" hole for the
mOUnttig
s rods at points "J" and "K" on the
wall template.
cabinet front
filler block
cabinet
bottom shelf
.
6
Find the points on the wti
m template labeled "D", "El', 'IF",
and "G". Drill a 3116" diameter hole at
the points that are over a
wall
stud and
a 3/4" diameter hole at the points that
are over drywall.
5
Measure the bottom of the upper-
. cabinet frame. Trim the edges
" A"
"$3" and "C" on the upper-cabinet
tem&e'so
that the template will fit
On
the bottom of the upper cabinet. If
upper cabinet has a recessed frame,
trim template so that it fits inside the
recessed area. Align the center line of
the upper-cabinet template
With
the
center line of the wall template; then
securely tape or tack the upper-cabinet
template in place.
Panel D
9
Drill a 3/V hole at points "L" and
m "M" on the upper-cabinet
template. Place a washer over each
114" x 2" bolt, Then insert a bolt down
through each hole in the Upper cabinet
bottom.
using a thin nail to probe the
wall,
, find and clearly mark the
two
template points closest to the center of
the wall stud(s) located within the
shaded area marked "H" on the Wah
template. Drill a
3/16"
hole into the
Wd
stud(s) at the two stud marks.
Advertisement
