Proper Sealants For Application; Striping And Decals - Tiffin Motorhomes 2014 Phaeton Owner's Manual

TIFFIN MOTORHOMES

Proper Sealants for Application

The following sealants are recommended for specific sealing applications, as noted in the table:
Plas-T-Cote
Surebond #SB-140
Carlisle #502-LSW Self-Leveling Sealant
Silicone Sealant
Parbond
Figure 13-3. Typical Striping and Decal
Design on Motor Home Exterior
Do not use solvents such as acetone, MEK, toluene, and the like on the decals. Any
solvent including alcohol may soften and smear colors. Do not use lacquer thinner
or paint thinner on decals. Do not overcoat the decals with clear paint. Do not
allow gasoline or other fuels to come into prolonged contact with the decals.
However, if this should occur, immediately flush the affected area with water.
–PHAETON®
Recommended Sealants for Specific Sealing Applications
SEALANT

Striping and Decals

The striping and decals (Figures 13-3, 4) on your motor home normally require very
little maintenance. Treat these as you would any painted surface on your motor
home. Wash them with mild soap and warm water or any retail car soap.
Never wash the motor home in direct sunlight, while the motor home is hot, or
with hot water. Rinse thoroughly to
prevent accumulation of any soap residues. Use caution with high-pressure wash
nozzles. Keep such nozzles at least 18
inches from the edge of the decals during any washing operations. If this is not
followed, high-pressure water nozzles may cause the decals to loosen and
subsequently to peel. Test small sections of decals when using any type of
cleaning solution.
Chapter 13
Metal or fiberglass roof
Rubber laminated to metal roof and ALL SKYLIGHTS
Rubber roof over wood base
To cover butyl and other sealants; not to be used as
the main sealant
To seal across tops of windows and the like on exterior
surfaces where silicon is not used
Important
ROUTINE MAINTENANCE
SOLUTION
13-4