2
180° - Scheibe
16
1
Adjust 180° disc
–
Loosen screw 3 at the 180° disc 4.
–
Turn crank 1 by hand into the position indicated in the display.
–
Place the front side of the 180° disc centrally on the initiator 5 in
said position.
–
Tighten screw 3 at the 180° disc.
–
Press key "RST".
If the adjustment is correct, the button sewing automat positions
in such a way that the crank 1 is exactly behind the needle bar
bush 2.
The following menu appears:
–
Check whether the needle bar crank is in the position as indicated
in the menu.
–
Correct position of the 180° disc, if necessary. For this purpose
press key "RST", then correct the 180° disc correspondingly.
–
Afterwards press key "RST" three times in order to go to the altered
reference position.
–
Check whether the crank 1 is in parallel position to the needle bar
bush 2.
–
If necessary, repeat the procedure.
5
4
3
180°-disc