Advertisement
GROUNDING INSTRUCTIONS
This heater is for use on 120 volts. The cord has a plug as shown at A in Figure
65.1. An adapter as shown at C is available for connecting three-blade
grounding-type plugs to two-slot receptacles. The green grounding lug
extending from the adapter must be connected to a permanent ground such as
a properly grounded outlet box. The adapter should not be used if a three-slot
grounded receptacle is available.
NOTE:
A 15AMP,120 Volts circuit is required. Dedicated circuit is preferred but not
essential in all cases, a dedicated circuit will be required if, after installation,
the circuit breaker trips or the fuse blows on a regular basis when the heater
is operating. Additional appliance on the same circuit may exceed the current
rating of the circuit breakers.
WARNING:
1. Ensure the power cord is not installed so that it is pinched or against a
sharp edge and ensure that the power cord is stored or secured to avoid
tripping or snagging to reduce the risk of fire, electric shock or injury to
persons.
2. Construction and electrical outlet wiring must comply with local building
codes and other applicable regulations to reduce the risk of fire, electric
shock and injury to persons.
Do not attempt to wire your own new outlets or circuits. To reduce the risk of
fire, electric shock or injury to persons, always use a licensed electrician.
SPECIFICATIONS
Technical Specifications
Model: EA1231
Voltage: 120V
Frequency: 60Hz
Power: 1500W
Call 1-877-744-3649 for assistance or email us at service@phoenixinno.com
MC
OPERATING INSTRUCTIONS:
Read all instructions and warnings prior to operating the appliance.
Ensure that all controls are in the "OFF" position before plugging the
appliance in to a properly grounded electrical outlet.
The control panel of the appliance is located, in the centre (See Fig. 1 and
Fig. 2).
Fig. 1
.
Fig. 2
When you first turn the heater on, it may emit a slight but harmless odor.
This odor results from certain oils or greases being heated as the appliance
is used for the first time. This odor is perfectly safe and will stop shortly – it
will not reoccur after the first operation of the appliance.
3
Advertisement
