Table of Contents
Advertisement
Configuring the Board
Table 1-2 MVME5500 Jumper Settings (continued)
Jumpers /
Switches
S4-2
S3-3
J34, J97, J98,
J99
J102 –J110
Items in brackets are factory default settings.
MVME55006E Single Board Computer Installation and Use (6806800A37E)
Function
PCI Bus 1.0 Speed
Header
EEPROM Write Protect
Header
Ethernet 2 Selection
Headers
(see also J6, J100, J7,
J101)
Refer to a note on page
20
for a configuration
limitation.
P2 I/O Selection Headers
Hardware Preparation and Installation
Settings
[OFF]
PMC board controls whether
the bus runs at 33 MHz or 66
MHz.
Forces PCI bus 1.0 to remain at
ON
33 MHz.
OFF
Disables EEPROM
programming
Enables EEPROM
[ON]
programming
1-2 on all
Rear P2 Ethernet
(set when in SBC/IPMC761
mode)
[No jumpers installed]
Front-panel Ethernet
1-2
PMC 2 I/O connected to P2
[2-3]
IPMC I/O connected to P2
19
Advertisement
Table of Contents
